Regularly, staff should master some troubleshooting and handling methods for high and low temperature alternating test chambers. If the equipment exhibits unstable low temperatures, what causes this phenomenon, and how should we address these faults?
Check the Electrical System of the Equipment
If the refrigeration compressor can start normally during operation, it indicates that the issue is not related to the electrical system.
Verify Whether the Refrigerant in the Refrigeration System Is Sufficient
During operation, inspect the temperature of the compressor’s exhaust and suction pipes. If the exhaust pipe temperature is not high and the suction pipe temperature is not low, it suggests a lack of refrigerant.
Inspect the Main and Auxiliary Units
When both the main and auxiliary units are operating simultaneously, the cooling rate of the equipment is relatively high. In the initial stage of temperature maintenance, both units work together. Once the temperature stabilizes, the main unit alone maintains the cooling and stability, while the auxiliary unit stops. If the main unit has a refrigerant leak, its cooling efficiency will weaken. Since both units operate together during cooling, unstable temperatures will not occur, but the cooling rate will decrease. During temperature maintenance, if the main unit fails to cool and the auxiliary unit is inactive, the temperature inside the chamber will gradually rise. When it reaches a certain level, the control system will activate the auxiliary unit to lower the temperature. Once the temperature drops sufficiently, it re-enters the maintenance phase. This cycle repeats, resulting in unstable low temperatures.
After identifying the cause of unstable low temperatures in the test chamber, what measures should be taken to resolve it?
For electrical system issues, technicians should repair the system.
If the refrigerant is insufficient, technicians should replenish it.
For problems with the main and auxiliary units, a combination of soapy water and leak detection devices can be used to locate leaks. Once found, the leaks should be repaired or the components replaced.
Temperature and humidity test chamber Salt spray test chamber Aging test chamber New Energy Test Chamber IP protection testing equipment Non standard customized laboratory High and Low Temperature Test Chamber Thermal Shock Test Chamber Constant Temperature and Humidity Test Chamber High and Low Temperature Low Pressure Test Chamber Salt Spray Test Chamber Rapid Temperature Change Test Chamber High and Low Temperature Alternating Humidity Test Chamber High and Low Temperature Humidity Test Chamber Low Temperature Test Chamber High Temperature Test Chamber High and Low Temperature Alternating Test Chamber Damp heat test chamber for antirust oil and grease UV Aging Test Chamber Ozone Aging Test Chamber Air-exchange Aging Test Chamber Rain Test Chamber Sand and Dust Test Chamber Sulfur Dioxide Test Chamber Mold Test Chamber Ultra-Low Temperature Test Chamber Salt Spray Corrosion Test Chamber Condensation Test Chamber HAST Test Chamber Thermal Vacuum Test Chamber Battery Explosion-proof Test Chamber battery test chamber Photovoltaic PV module UV test chamber Sunlight simulation test chamber Photovoltaic wet freezing test chamber Photovoltaic Dustproof Test Chamber
EN
中文
Pусский
Ti?ng Vi?t
???????
???????? ????
